Yamaha Turn Signal Adapters Spacers .

[Limey]

Anyone have info on the front turn signal adapter plate? Looking to install a set of LED turn signals with 10 mm thread. Done the rears with the Camel ADV Tail Tidy .

[johnnygolucky]

Right here. And a lot cheaper than the T7rally and quicker. 

 

https://www.amazon.com/gp/product/B01BH5YH4G/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

 

[Cruizin]

1 hour ago, Limey said:

Anyone have info on the front turn signal adapter plate? Looking to install a set of LED turn signals with 10 mm thread. Done the rears with the Camel ADV Tail Tidy .

Moving this to the tech questions section as this is not a tech tip. 

[concours]

On 7/13/2020 at 7:11 PM, johnnygolucky said:

Right here. And a lot cheaper than the T7rally and quicker. 

 

https://www.amazon.com/gp/product/B01BH5YH4G/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

 

Are these relatively durable? The fragile-as-ribbon-candy Shet that came with the Cyclops lights are a bad joke. 

[Subsea]

I got those linked above from Amazon. They crumbled to pieces. I replaced them with sets from Yoshimura which are a lot better though more expensive.

[johnnygolucky]

4 hours ago, concours said:

Are these relatively durable? The fragile-as-ribbon-candy Shet that came with the Cyclops lights are a bad joke. 

Tough as nails. If you can brake one with your bare hands, join a circus. 

 

That said, they were off maybe a fraction of a millimeter on the thicker part that "snaps" into the Yamaha fearing. 2 minute fix with a tiny trim with a Dremmel. The plastic is VERY VERY hard so a tiny carving bit just to "sand" one side of the raised edge worked great. Been on the bike since last year and zero issues. The signals will break LONG before the inserts do. 

Edited March 18, 2021 by johnnygolucky